|
LifeCenter21 Introduction: Editing the Lab Contract
Important Note: This tech tip is applicable
to the LC21 Introduction Unit module revision B and all management
systems.
Issue
The Lab Contract in the Introduction Unit can be
edited to fit the individual needs of each school
Action
At one workstation, do the following:
1.
Exit LC21 and disable any file protection.
2.
Open Windows Explorer (Start, Programs,
Windows Explorer).
3.
Locate your TC21_EXE folder
(usually on your C: drive) and double click on that folder.
4.
Double click on the tcf12.
5.
Double click on the Xfer_spt
folder.
6.
Double click on the file named Contract.rtf to open the file into WordPad (or
Word).
7.
Edit the document as desired and save it
(do not rename the file to a different filename).
8.
Close WordPad (or Word).
9.
Using a blank floppy, save the Contract.rtf file to the A: drive. Click once on
the Contract.rtf file to highlight the file and then click File ... Send To
... 3½ Floppy (A).
At all the other workstations, do the following:
1. Exit
LC21, disable any file protection, and insert the floppy into the floppy
drive.
2.
Open Windows Explorer (Start, Programs,
Windows Explorer).
3.
Scroll up on the left side and click on
the A: drive.
4.
On the right side, click once on the file
named Contract.rtf to highlight it.
5.
Click on Edit and then Copy.
6.
Scroll down until you locate your TC21_EXE
folder (most likely found in the C: drive) and double click on that folder.
7.
Double click on the tcf12 folder.
8.
Double click on the Xfer_spt
folder.
9.
Click on Edit and then Paste.
10.
When prompted that this folder already
contains a file named 'Contract.rtf', click Yes.
11.
Close Windows Explorer and remove the
floppy from the floppy drive.
12.
Log onto the Introduction Unit to see if
your edited Lab Contract correctly appears.
13.
Repeat steps 1 through 12 on the remaining
workstations.
If you have
any questions, please feel free to call AES Technical Support for assistance.
|